human knee

英

美

[网络] 人的膝盖

网络

双语例句

• Optimization computation of 14 mechanism parameters of 4-bar knee joint is used to make it track human knee joint and damper cost minimum energy.
  通过对膝关节机构参数的多变量最优化设计，保证仿生腿各关节中心点跟踪给定轨迹，且阻尼器能耗小。
• The Kinematical Parameters Measurement of the Three Dimensional Freedom Degrees of Human Knee
  膝关节三自由度运动的测试分析
• The results show that for human knee joints the failure torque is 69.9 ± 9.7 ( Nm), and the failure tension is 1412 ± 117 ( N).
  结果表明：人体膝关节的破坏扭矩为69.9±9.7Nm，破坏张力为1412±117N。
• Human knee joint is the most important body part and the multiple lesions part.
  人体膝关节是人体最重要的部位，也是多发病变部位，一般严重受损的膝关节都采用全膝置换术来治疗。
• Establish the model of human knee in order to study its biomechanics mechanism.
  正常国人急性意外死亡的膝关节模型制作，研究其生物力学机制；
• The contact location, contact area and stress distribution of the patellofemoral joint were tested with the Fuji pressure sensitive film and the dyeing method in eight fresh human cadaver knee joints under the states of variety Q-angles and knee flexion angles.
  本研究应用染色法和压敏片法，对8例新鲜尸体膝关节在不同Q角和屈膝角度时的髌股接触部位、面积和应力分布进行测试。
• The research finding of biomechanics of the human knee in vivo is not only as a reference to deeply understand the behavior of joints, protect joints consciously against injury, but also as a tool to identify the treatment of knee pathologies.
  同时膝关节生物力学特性的研究对人类深入认识关节行为，有意识的保护关节，减少关节损伤以及确定关节伤病后的康复方案提供参考。
• Objective: Collect the normal image of CT and MRI scans of the knee, take advantage of the three-dimensional reconstruction and ANSYS three-dimensional finite element softwares to the establishment of dimensional finite element model of the normal human knee.
  目的：收集正常人膝关节CT及MRI扫描图像，利用三维重建及ANSYS等三维有限元软件，建立正常人膝关节三维有限元模型。
• 4-bar closed-chain knee joint controlled by intelligent MR damper has polycentric characteristic of human knee joint.
  由智能阻尼器控制的4-bar封闭链仿生膝关节转动中心是变化的。
• Joint between the femur and tibia in a quadruped; corresponds to the human knee.
  四足动物大腿骨和胫骨之间的关节；与人类的膝盖对应。